Publication:
Effect of spraying parameters on the morphology of spraycoated active layers for organic solar cells

No Thumbnail Available
Date
2018
Authors
Razali N.T.
Kamarudin K.
Inaba S.
Yusof M.
Leong Y.W.
Vohra V.
Journal Title
Journal ISSN
Volume Title
Publisher
Science Publishing Corporation Inc
Research Projects
Organizational Units
Journal Issue
Abstract
Over the past decade, organic solar cells (OSCs) have demonstrated their great potential for the low-cost mass production of renewable energy. However, the conventional active layer deposition technique (spin-coating) is not suitable for mass production due to its incompatibility with the roll-to-roll process. Spray-coating is a promising candidate for in-line production of OSCs but parameters such as distance between the spray nozzle and substrate, applied pressure and number of sprays should be optimized to produce adequate film thickness and morphology. Here, we verified how these processing parameters influence the thin film properties and observed that film thickness increases with decreasing nozzle-substrate distance, increasing number of sprays or applied pressure. The processing parameters were adjusted to produce spray-coated films with similar properties to the spin-coated ones thus confirming that spray-coating could replace spin-coating for mass production of OSC devices. � 2018 Authors.
Description
Keywords
Citation
Collections