Publication: Evaluation of the effectiveness of elastomeric mount using vibration power flow and transmissibility methods
No Thumbnail Available
Date
2017
Authors
Arib Rejab M.N.
Abdul Shukor S.A.
Mohd Sofian M.R.
Inayat-Hussain J.I.
Nazirah A.
Asyraf I.
Journal Title
Journal ISSN
Volume Title
Publisher
Institute of Physics Publishing
Abstract
This paper presents the results of an experimental work to determine the dynamic stiffness and loss factor of elastomeric mounts. It also presents the results of theoretical analysis to determine the transmissibility and vibration power flow of these mounts, which are associated with their contribution to structure-borne noise. Four types of elastomeric mounts were considered, where three of them were made from green natural rubber material (SMR CV60, Ekoprena and Pureprena) and one made from petroleum based synthetic rubber (EPDM). In order to determine the dynamic stiffness and loss factor of these elastomeric mounts, dynamic tests were conducted using MTS 830 Elastomer Test System. Dynamic stiffness and loss factor of these mounts were measured for a range of frequency between 5 Hz and 150 Hz, and with a dynamic amplitude of 0.2 mm (p-p). The transmissibility and vibration power flow were determined based on a simple 2-Degree-of-Freedom model representing a vibration isolation system with a flexible receiver. This model reprsents the three main parts of a vehicle, which are the powertrain and engine mounting, the flexible structure and the floor of the vehicle. The results revealed that synthetic rubber (EPDM) was only effective at high frequency region. Natural rubber (Ekoprena), on the other hand, was found to be effective at both low and high frequency regions due to its low transmissibility at resonant frequency and its ability to damp the resonance. The estimated structure-borne noise emission showed that Ekoprena has a lower contribution to structure-borne noise as compared to the other types of elastomeric mounts. � 2017 Published under licence by IOP Publishing Ltd.
Description
Dynamics; Engine mountings; Flexible structures; Natural frequencies; Rubber; Stiffness; Structural design; Synthetic rubber; Vibration analysis; 2 degree of freedoms; Dynamic stiffness; Flexible receiver; High frequency HF; Low and high frequencies; Structure-borne noise; Vibration isolation systems; Vibration power flow; Electric load flow