Publication: Calibration of rugged, renewable and fast response temperature probes in a hypersonic flow facility
No Thumbnail Available
Date
2010
Authors
Mohammed H.
Salleh H.
Yusoff M.Z.
Journal Title
Journal ISSN
Volume Title
Publisher
American Society of Mechanical Engineers (ASME)
Abstract
This paper presents a dynamic calibration technique of rugged, renewable and fast response temperature probes (TP) in a hypersonic testing facility. Two types of scratch were used, mainly abrasive papers with different grit sizes and scalpel blades with different thicknesses to form the probe junction. The effect of scratch technique on probe's thermal product is investigated. The probes were tested and calibrated in the test section and in the end wall of UNITEN shock tube facility at different axial and radial locations. It was observed that the thermal product of a particular TP depends on the Mach number, surface junction scratch technique, junction location as well as on the enthalpy conditions. It was also noticed that using scalpel blade technique with a particular blade size gives consistent thermal product values. Thus, it does not require an individual calibration. However, for TP whose junction created using abrasive paper technique with different grit sizes, a calibration for each TP is likely to be needed. The results from shock tube tests have shown that, these probes have a response time on the order of microseconds (50 us) with a rise time less than (0.5 us), and were suitable for making the heat transfer measurements in highly transient conditions. Copyright � 2010 by ASME.
Description
Keywords
Abrasives , Calibration , Dynamic response , Facilities , Location , Mach number , Mechanical engineering , Shock tubes , Dynamic calibration , End-wall , Fast response , Grit size , Heat transfer measurements , Radial locations , Response time , Risetimes , Shock tube facility , Surface junctions , Temperature probes , Test sections , Testing facility , Thermal products , Transient conditions , Probes